This might actually be a good opportunity for an AI answer:

–

First, understand the basic principle you’re working with:

Shopping cart wheel locks respond to a specific RF (radio frequency) signal (typically around 7.8 kHz to 10 kHz for many systems, but it varies by brand).

In normal operation, the boundary wire emits this signal constantly.

The unlocking posts emit a different coded signal to reset the wheel.

So to design a portable device that could lock and unlock wheels manually anywhere, you would need:

1. Identify the Signals

You must figure out the exact frequencies and modulation patterns used by the cart system.

Different companies (like Gatekeeper Systems, Carttronics, etc.) use slightly different RF signatures.

Usually lock signal = basic broadcast (constant tone) Unlock signal = special modulated unlock code or sequence.

This might require:

A spectrum analyzer

Or reverse-engineering an existing unlock station.

2. Design the Portable Emitter

The portable device needs:

A programmable low-frequency RF transmitter (around 8–10 kHz range, low power)

A microcontroller (Arduino, ESP32, etc.) to generate the right modulation if the signal is coded

An amplifier to make the signal strong enough to reach the cart wheels (they usually detect it within 3–10 feet)

Optionally:

Two modes: a “lock” mode (sending the boundary signal) and an “unlock” mode (sending the unlock code).

3. Basic Hardware Components

Low-frequency oscillator (to generate 7.8–10 kHz wave)

Microcontroller (to handle switching, coding)

Coil antenna (for strong near-field transmission — like a small induction coil)

Amplifier circuit (boost the signal so carts sense it a few meters away)

Battery pack (portable, rechargeable — say 12V lithium-ion)

Mode selector switch (Lock / Unlock)

4. Software

Simple microcontroller code to:

Emit plain carrier signal = Lock mode

Emit modulated code = Unlock mode

Example (pseudo-Arduino code):

if (mode == LOCK) { generateContinuousTone(8kHz); } else if (mode == UNLOCK) { generateUnlockCode(); }

5. Important Challenges

Matching signal format exactly: If the unlock signal is digitally modulated (like FSK or ASK), you must match the timing perfectly.

Power levels: Too much power could fry circuits or interfere with nearby electronics. Keeping it safe is key.

Legal considerations: Broadcasting radio signals, even low-power ones, can be restricted depending on the country.

Simple Concept Sketch:

[Portable RF Cart Lock/Unlock Device]

Size: About a large walkie-talkie

Two buttons: Lock / Unlock

Coil antenna: About 3–6 inches

Range: 1–3 meters effective

Display: Small LED indicators (Locking / Unlocking / Signal OK)

In short: You’re essentially building a portable invisible “fence” generator with two channels: a “keep away” signal (lock) and a “come back” signal (unlock).

Interesting thank you! Not yet the tiny no bells no whistles electric pickup I’m hoping for, but it’s nice to see Canadian alternatives for things i didn’t know we did!

My exact thought! I wish a Canadian startup did exactly that, I’d buy one immediately

Just donated to Wikipedia. Will do every time this fuckers brings it up